[어보브반도체(주)]

• 8-bit CISC Core (M8051EW, 2clock/cycle)
• 8KB Flash
• 512B SRAM
• 256B Data Flash
• 16-bit H/W CRC/Checksum
• 16-bit Timer X 3
• 8-bit X 1
• 8-bit WDT X 1
• USART (UART + SPI) X 1
• OP-Amp X 2
• 10-bit ADC
• Constant Sink Current Generator X 2 (Max 287mA)
• Internal 4Mhz RC oscillator
• LDO 5.0V ±1.0% (TA=25°C) For VDD
• Comparator for Line Interface Rx
• TR for Line Interface Tx
• Temperature sensor
• LVR (1.6V,2.2V,2.4V,2.7V)
• On chip debug and ISP
• 16-SOPN

Getting Started

• Install the driver of OCD or OCD II on PC
• Check jumper position on Starter Kit
• Connect the Starter Kit to PC via USB cable
• Check whether the PC recognizes the USB device normally from the Device Manager (Device should be recognized as OCD or OCD II or as HID device)
• Create source code projects and compile
• Download execution code to Starter Kit by using dedicated downloader or debugger
• Press reset button from Starter Kit or click run button of debugger
** The OCD or OCD II driver; demo software and example codes of Starter Kit can be downloaded from ABOV website